Dito Sama 600418 User Manual

Refer to the numbered drawings that relate to the numbered paragraphs
in the instruction manual
The reference language for these instructions is French.
Contents
Introduction
Installation
Use and safety
Cleaning, hygiene and storage
Fault-fi nding
Introduction
The User Manual contains useful information for
the user on how to work correctly and in complete
safety, and is designed to make it easier to use the
machine (called "machine" or "appliance" below).
What follows is in no case intended to be a long list of warnings
and constraints, but rather as a series of instructions meant to
improve the service provided by the machine in every respect,
and particularly to avoid a series of injuries or damage to equi-
pment that might result from inappropriate procedures for use
and management.
It is essential that all the people responsible for transporting,
installing, commissioning, using, maintaining, repairing or
dismantling the machine should consult this manual and read
it carefully before proceeding with the various operations, in
order to avoid any incorrect or inappropriate handling that
might be result in damage to the machine or put people's
safety at risk.
•
Read the instruction manual carefully before using the
appliance.
• Keep the instruction handbook for future reference.
• Install the appliance in a well-ventilated place
sos
• Place emergency telephone numbers in a visible
position.
• Installation and maintenance must only be carried out
by qualifi ed personnel authorised by the manufacturer. For
assistance, contact an authorised service centre.Demand
original replacement parts.
• The appliance must not be used by people (including
children being supervised not to play with the appliance)
with limited physical, sensory or mental abilities or without
experience and knowledge of it, unless instructed in its use
and supervised by those responsible for their safety.
• The appliance must be used by trained personnel about
the risks involved.
• Do not leave the appliance unattended when operating.
• Turn the appliance off in case of fault or poor operation.
• Do not use products (even if diluted) containing chlorine
(sodium hypochlorite,hydrochloric or muriatic acid,etc.) to
clean the appliance or the fl oor under it. Do not use metal
tools to clean steel parts (wire brushes or Scotch Brite type
scouring pads).
• Do not allow oil or grease to come into contact with
plastic parts.
• Do not allow dirt, fat, food or other residuals to form depo-
sits on the appliance.
Failure to observe the above can compromise the safety of the appliance. Failure
to observe the above invalidates the waranty.
1 Maintenance
1 Compliance with regulations
3 Parts list - exploded view
5 Electrical diagrams
5
It is just as important that the Manual should always be avai-
lable to the operator and it should be kept carefully where the
machine is used ready for easy and immediate consultation in
case of any doubt, or in any case, whenever the need arises.
If after reading the Manual, there are still any doubts concerning
how to use the machine, please do not hesitate to contact the
Manufacturer or approved After Sales Service provider, who
is constantly available to ensure quick and careful service for
improved machine operation and optimum effi ciency.
Note that the safety, hygiene and environmental protection stan-
dards currently applicable in the country where the machine is
installed must always be applied during all phases of machine
operation. Consequently it is the user's responsibility to ensure
that the machine is operated and used solely under the optimum
safety conditions laid down for people, animals and property.
• Do not clean the appliance with direct jets of water.
• This handbook is available in digital format by contacting
the dealer or reference customer.
• Install a circuit breaker ahead of the appliance. The contact
opening distance and max.leakage current must comply with
the regulations in force.
• The appliance must be earthed; Connect to appliance to an
earth; it must be included in an equipotential node by means
of the screw located under the frame. The screw is marked
with the symbol .
• It is advisable to have the appliance inspected by an au-
thorised person at least every 12 months. For this purpose,
it is advisable to stipulate a servicing contract.
• Persons wearing pacemakers should see a doctor
to know if their safety is guaranteed near this type of
appliance.
• The symbol given on the product indicates
that it should not be considered domestic waste, but
must be correctly disposed of in order to prevent any
negative consequences for the environment and the
health of persons.For further information regarding
the recycling of this product, contact the product
agent or local dealer, the after-sales service or the
local body responsible for waste disposal.
• The symbol
that the operator's manual should be read before continuing
the operation.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualifi ed persons
in order to avoid a hazard.
1
« Read operator's manual» indicate
TR2S GB 02 2017
GB
05/2019
6
7
A
C