MIL-240FXT/MIL-240FXC Redundant Port Selector SC Connector Main Port MIL•240FXC 100BASE-FX Redundant Port Selector SC Connector Selector Primary Port Backup Port SC Connector SC Connector Installation Guide This guide includes the following information: “About this manual” on page 2 “Introduction” on page 2 “Features”...
Page 2
Install Guide A b ou t th i s m a nua l This manual covers both the MIL-240FXT and the MIL-240FXC. The terms “MIL- 240FX,” “transceiver,” and “device” are used throughout this document to describe either transceiver. I ntrod uct i o n The MIL-240FXC/240FXT is a 100BASE-FX, fault-tolerant transceiver.
Page 3
Primary Port (BPSD may be on). When MPSD and BPSD illuminate at the same time, the node attached to the Main Port is connected to the node attached to the Backup Port (PPSD is off). Model: MIL-240FXC/MIL-240FXT Main Port 5 V DC 1.5 A...
Page 4
Op era t i n g Condi t i ons Table 1: Recommended Operation Conditions Operating Temperature Humidity: Non-condensing Signal Output Load Supply Voltage Ambient Operation Model: MIL-240FXC/MIL-240FXT ST Connector (rear view) (rear view) Figure 2. Connections Parameters Minimum +5° C 35 ohm 4.75 V...
Page 5
L eg al Regulat o r y A pprovals • FCC Class A • UL 1950 • CSA 22 No. 950 • EN60950 • – EN55022 Class B – EN50082-1 Canad ia n EM I No tice This Class A digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations.
Need help?
Do you have a question about the MIL-240FXC and is the answer not in the manual?
Questions and answers