I Operating Principle; I Pool Preparation - Polaris W 445 Installation And User Manual

1.3 I Operating principle

The cleaner is separate from the filtration system and can function independently. It just simply needs to be connected
to the mains power supply.
It finds the best route to move around and clean the areas of the pool for which it has been designed (depending on the
model: floor, walls, waterline). Debris is sucked in and stored in the cleaner's filter.
The control box enables the cleaning operations to be started, selected and programmed (depending on the model).

1.4 I Pool preparation

• This product is intended to be used in pools which are permanently installed. Do not use it in
pools which may be dismantled. A permanent pool is built into the ground or on the ground
and cannot be easily dismantled and stored.
• The appliance must operate in pool water with the following properties:
Water temperature
• When the pool is dirty, especially when commissioning, remove the largest debris using a net in order to optimise the
appliance's performances.
• Remove any thermometers, toys and other objects that might damage the appliance.
7
3.5 metres
Minimum
pH
Free chlorine
Between 15°C and 35°C
Between 6.8 and 7.6
< 3 mg/ l
: Control box
: Trolley
: Cleaner
: Floating cable
: Plug
: Power cord