Operation; Opening The Window - Dometic I-Lux Installation And Operating Manual

I-Lux
See fig. 7
1. Place the outer frame in the middle of the wall section.
2. Press the outer frame slightly onto the wall so that the sealing compound
spreads out.
See fig. 8
A
NOTICE! Damage hazard
Only use a torque controlled screwdriver with a max. torque of 1.5 Nm
for fastening the screws to prevent damaging the window frame.
➤ Fasten the screws with a torque controlled screwdriver.
✔ The fixation elements automatically rotate into the correct position.
See fig. 9
1. Attach the inner frame to the outer frame.
The centering pins (1) must fit into the fixation elements (2).
2. Remove the protective film from both sides of the acrylic glass.
I
NOTE
If the protective film is exposed to sunlight for too long, it cannot be
taken off without leaving a residue.
3. After installing, check that the window and the blind system work properly.
7

Operation

7.1

Opening the window

Supplementary to fig. 0
1. Press the sliding button towards the window and keep it pressed and simultane-
ously turn the handle by 90°.
✔ The window handle is unlocked.
2. Repeat step 1 with the other handles.
3. Tilt the window pane outwards until it reaches the required opening angle.
EN
Operation
7