Levelling The Appliance - LG F2T208WSE Owner's Manual

INSTALLATION
14
WARNING
• Repairs to the appliance must only be carried out
by qualified personnel. Repairs carried out by
inexperienced persons may cause injury or
serious malfunctioning. Contact your local
authorised LG repairer.
• The power plug must be plugged into an
appropriate outlet socket that is installed and
grounded/earthed in accordance with all local
codes and ordinances.

Levelling the Appliance

Removing the Transit Bolt
Assemblies
CAUTION
• To prevent the appliance from severe vibration
and breakage, remove transit bolts and
retainers.
4
X
4
X
1
Remove the 4 transit bolts and rubber spacers
from the rear of the appliance.
2
Loosen the transit bolts by turning them
anticlockwise with an appropriate spanner.
1
3
3
Remove the transit bolts with a straight pull.
4
Fit the plastic blanking caps supplied in the
accessories bag into the gaps left by the
removal of the transit bolts. The transit bolts
should be stored for future use.
Checking the Level
When pushing down the edges of the top plate
diagonally, the appliance should not move up and
down at all (check both directions).
• If the appliance rocks when pushing the top
plate of the appliance diagonally, adjust the feet
again.
• Check whether the appliance is perfectly level
after installation.
NOTE
• Timber or suspended type flooring may
contribute to excessive vibration and unbalance.
Reinforcement or bracing of the timber floor
may need to be considered to stop or reduce
excessive noise and vibration.
• Never try to level any uneven floor by putting
pieces of wood, cardboard or similar materials
under the appliance.
4
X
Adjusting and Levelling the
2
Feet
When installing the appliance, the appliance
should be aligned and perfectly level. If the
appliance is not aligned and level properly, the
appliance may be damaged or may not operate
properly.
1
4
Loosen the plastic locking nut.
• Do not insert pieces of wood etc. under the
feet.