Rigol M300 Series Manual

Modules/Terminal Block Supported by M300
Module
DMM-MC3065
MUX20-MC3120
MUX32-MC3132
MUX64-MC3164
MIX24-MC3324
1 RIGOL
Terminal Block
·DMM module
·Used to measure the signal
·6½ digits
MC3065 doesn't need ·Support the following functions: DCV, ACV, DCI, ACI,
terminal block 2WR, 4WR, FREQ, PERIOD, TEMP and any sensor
·After connecting the DMM module, make sure that
the signal under test connected to the analog bus is no
greater than 300 Vdc or 300 Vrms
·20-channel multiplexer
·All 20 channels switch both HI and LO inputs
·Support 4-wire measurement
·The signal to be tested is connected through the M3TB20
terminal block
·Can be connected with MC3065
M3TB20
·32-channel multiplexer
·All 32 channels switch both HI and LO inputs
·Support 4-wire measurement
·The signal to be tested is connected through the M3TB32
terminal block
·Can be connected with MC3065
M3TB32
·64-channel single-ended multiplexer
·All 64 channels can switch HI input only
·Doesn't support 4-wire measurement
·The signal to be tested is connected through the M3TB64
terminal block
·Can be connected with MC3065
M3TB64
·Mixed multiplexer with 20 voltage channels and 4 current
channels
·All 20 voltage channels switch both HI and LO inputs
·20 voltage channels support 4-wire measurement
·4 current channels are used to measure DC current or
AC current
·The signal to be tested is connected through the M3TB24
terminal block
M3TB24
·Can be connected with MC3065
M300
Series
Description