Table of Contents
Advertisement
16
www.aeg.com
Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
DEMO appears on the dis‐
play.
A
or
shown instead of numbers
on the temperature display.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Possible cause
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The "FROSTMATIC func‐
tion" is switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The door has been opened
often.
The FROSTMATIC function
is switched on.
There is no cold air circula‐
tion in the appliance.
The appliance is in demon‐
stration mode.
Temperature sensor prob‐
or
symbol is
lem.
Solution
Attach the melting water out‐
let to the evaporative tray.
Switch off "FROSTMATIC
function" manually, or wait
until the function deactivates
automatically to set the tem‐
perature. Refer to "FROST‐
MATIC function" section.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
Refer to "FROSTMATIC
function" section.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
Tips" chapter.
Keep the OK key pressed for
approximately 10 seconds
until a long sound is heard
and the display turns off for
a short time.
Contact the nearest Author‐
ized Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
8.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Advertisement
Table of Contents
