Table of Contents
Advertisement
12
OPERATING INSTRUCTIONS
PRESS FILTER
RESET BUTTON
TIMER: DELAY STOP/START FEATURE:
THEN DO THIS:
PRESS UP/DOWN
BUTTONS
YOU WILL SEE HOW MUCH TIME IS
CHOSEN:
To delay stop(or start), press the Timer
button when the unit is power-on(or
power-o ), then the "timer o " indicator(or
"timer on" indicator) will illuminate. Then
adjust timer setting, tap or hold the UP
arrow ( ) or the DOWN arrow ( ) to
change delay timer at 0.5 hour increments,
up to 10 hours, then at 1 hour increments up
to 24 hours. The setting will be confirmed
automatically in 5 seconds, then the control
will count down the time(8, 7.5, 7, etc.) left,
and all other settings will remain the same
as they were before the timer setting is
confirmed, until stop(or start).
DO THIS:
FIRST DO THIS:
PRESS TIMER
BUTTON
Setting combination of "delay stop
delay start" or "delay start
is workable. Both "timer o " indicator and
"timer on" indicator will illuminate then. The
timer setting can be canceled by either
pressing and holding the timer button for 2
seconds, or pressing the power on/o
button at any time to turn o the unit
directly.
REMOTE SENSING FEATURE
(on some models):
This feature can be activated from the
remote control ONLY, the unit must be in a
cooling mode. To activate the remote
sensing feature, point the remote control
towards the unit and press the Remote
Sensing button. Next, use the "
to set the desired temperature at the
remote. (Note that the set temperature will
only be displayed on the unit itself ). The
LIGHT on the unit control will illuminate to
indicate it receives the signal. The LIGHT on
the remote control will pulse each time it
sends a signal. lt will periodically send this
signal until the feature is deactivated by
pressing the remote sensing button again. lf
the unit does not receive the remote sensing
signal during any 7 minute interval, the
Remote Sensing feature will halt until the
unit receives signal from the remote control
again. The display on the remote control
indicates the temperature at the remote
ONLY.
turn off
delay stop"
turn on
" buttons
DO THIS:
PRESS REMOTE
SENSING BUTTON
Advertisement
Table of Contents
