Advertisement
Installation Guide
Speed gates OTSG9000 series
Applicable Model(s): OTSG9000, OTSG9011, OTSG9022, OTSG9033,
OTSG9200, OTSG9211, OTSG9222, OTSG9233
Version: 1.0
Date: June 2019
Advertisement
Table of Contents
Related Manuals for Turnstiles OTSG9011
Summary of Contents for Turnstiles OTSG9011
- Page 1 Installation Guide Speed gates OTSG9000 series Applicable Model(s): OTSG9000, OTSG9011, OTSG9022, OTSG9033, OTSG9200, OTSG9211, OTSG9222, OTSG9233 Version: 1.0 Date: June 2019...
- Page 2 The power and signal wires should be set separately to easily distinguish strong and weak power. Please invite professional personnel to complete the wiring. The device must be connected to the ground. Below is the outline and dimensions: Figure 1-1 www.TURNSTILES.us | patrick.mcallister@TURNSTILES.us | 303-670-1099...
- Page 3 At the same time, check if the indicators work properly. If everything works fine, you can fasten the ground screw nuts and fix the device. If an exception occurs, please contact your vendor. www.TURNSTILES.us | patrick.mcallister@TURNSTILES.us | 303-670-1099...
- Page 4 Opening duration (Press ‘ENT’ to modify) After the gate is opened, it will automatically close if no one passes through within a certain time duration. The default value is 5 seconds. The value ranges from 2 to 60. www.TURNSTILES.us | patrick.mcallister@TURNSTILES.us | 303-670-1099...
- Page 5 Into the counter 10. Gate closing delay time Time: 0~10 (default 0) 11. Brake unlock mode Mode: Delay unlock (default) 12. Brake starting angle Angle: 1~10 (default 3) 13. Fire alarm signal Signal: right open www.TURNSTILES.us | patrick.mcallister@TURNSTILES.us | 303-670-1099...
- Page 6 Area selection: Disable during In and out of infrared (default) All infrared zone anti-pinch 18. Memory opening Whether to open: No (default) 19. System working mode Mode: working mode (default) Test mode Restore to factory 20. Version number: Version: V9.0.0 www.TURNSTILES.us | patrick.mcallister@TURNSTILES.us | 303-670-1099...
- Page 7 IR sensor is covered. In the process of self-test, there are obstacles, When the gate is self-tested, the swing arm please remove the obstacles, restart the self- is not in the normal closing position! test after power-on! www.TURNSTILES.us | patrick.mcallister@TURNSTILES.us | 303-670-1099...
- Page 8 5 Wiring Diagram Below is the wiring diagram: Figure 5-1 www.TURNSTILES.us | patrick.mcallister@TURNSTILES.us | 303-670-1099...
Need help?
Do you have a question about the OTSG9011 and is the answer not in the manual?
Questions and answers