Table of Contents
Advertisement
Hardware Setup
Tools and Parts for Component Installation
Please prepare the following tools and parts before setting up your Synology NAS:
• A screwdriver (only for 2.5" drives)
• At least one 3.5" or 2.5" SATA drive (please visit
models)
Warning:
If you install a drive that contains data, the system will format the drive and erase all existing data.
Please back up any important data before installation.
Install Drives
1 To remove the drive tray, pull on the circled area in the indicated direction as shown in the image below.
2 Load drives in the drive trays.
• For 3.5" drives: Remove the fastening panels from the sides of the drive tray. Place the drive in the drive
tray. Then insert the fastening panels to secure the drive in place.
• For 2.5" drives: Remove the fastening panels from the sides of the drive tray and store them in a safe
place. Place the drive in the area of the drive tray indicated by a blue rectangle below. Turn the tray upside
down and tighten the screws to secure the drive in place.
9
www.synology.com/compatibility
for compatible drive
2
Chapter
Advertisement
Table of Contents
