Synology Ds920+ At A Glance - Synology DS920+ Hardware Installation Manual

Synology DS920+ at a Glance

6
No. Article Name
1
Status Indicator
2
Drive Status Indicator
3 Drive Tray Lock
4
USB 3.0 Port
5 Power Button
6 Drive Tray
7 LAN Port
8
RESET Button
9 eSATA Port
10
Power Port
11
Fan
Kensington Security Slot
12
USB 3.0 Port
13
1
For more information about Synology Expansion Unit supported by your Synology NAS, please visit www.synology.com.
4 Chapter 1: Before You Start
1
2
7
3
8
4
9
10
5
Location
Displays the status of the system. For more information, see "LED
Indicator Table".
Displays the status of each drive. For more information, see "LED
Indicator Table".
Lock or unlock drive trays.
Front
Connect external drives or other USB devices to the Synology NAS here.
1. Press to power on your Synology NAS.
2. To power off your Synology NAS, press and hold until you hear a beep
sound and the Power LED starts blinking.
Install drives (hard disk drives or solid state drives) here.
Connect network cable here.
1. Press and hold until you hear a beep sound to restore the IP address,
DNS server, and password for the admin account to default.
2. Press and hold until you hear a beep, then press and hold again until
you hear three beeps to return the Synology NAS to "Not Installed"
status so that DiskStation Manager (DSM) can be reinstalled.
Connect external SATA drives or Synology Expansion Unit
Rear
Synology NAS here.
Connect power cord here.
Disposes of excess heat and cools the system. If the fan malfunctions,
the Synology NAS will emit a beeping sound.
Attach a Kensington security lock here.
Connect external drives or other USB devices to the Synology NAS here.
Description
1
to the
11
12
13