Denali MA11145 Quick Start Manual

Plow mount for canam outlander

Thank you for purchasing our DENALI plow mount. You now own a premium custom

plow mount to allow you to use your plow with your ATV. Please note the following

instructions and heed all warnings.

• Your ATV and/or plow system can cause death or injury, please use caution and

common sense when operating your unit.

• Read your Plow Operator Manual, your Winch Operator Manual, and all warning

labels before operating your ATV.

• Operate your ATV at a walking speed with the blade installed. Do not exceed 5

mph (8 km/h), even with the blade up.

• Do not operate the ATV on slopes greater than 10 degrees with the plow

installed.

• Always lower the plow to the down position before leaving your ATV unattended.

SEVERE INJURY OR DEATH MAY RESULT IF YOU ARE NEGLIGENT.

866.527.7637

DENALI Plow Mount

MA11145

CanAm Outlander

motoinfo@motoalliance.com

Table of Contents

Need help?

Do you have a question about the MA11145 and is the answer not in the manual?

Page 1 DENALI Plow Mount MA11145 CanAm Outlander Thank you for purchasing our DENALI plow mount. You now own a premium custom plow mount to allow you to use your plow with your ATV. Please note the following instructions and heed all warnings.
Page 2 Rogers, MN 55374 866.527.7637 Please verify that all hardware and parts are included in your package. Kit Contents: Item Number Description Quantity MA11145 Mounting Plate ½-13x1.5” Hex Bolt ½” Washer MA11145-4 (Bigger Bracket) MA11145-3 (Smaller Bracket) ½” Lock Washer 866.527.7637...
Page 3 CanAm Outlander MA11145 22000 Industrial Blvd Rogers, MN 55374 866.527.7637 Plow Mount Assembly: 1. Locate notch on the plastic skid plate. See Figure 1. FIGURE 1 2. Locate the hole on the metal skid plate to the right and left of the notch 3.
Page 4 6. Mark where the holes are and drill out a half inch hole. See Figure 3. FIGURE 3 7. Place the smaller bracket, MA11145-3, above the holes drilled next to the bolt indent. 8. Place the bigger bracket, MA1145-4, above the holes drilled next to the notch.
Page 5 CanAm Outlander MA11145 22000 Industrial Blvd Rogers, MN 55374 866.527.7637 9. Raise plow mount up to the plastic skid plate and insert and all for ½” bolts with washer and lock washer then tighten the bolts. See Figure 4. FIGURE 4 Plow Installation: 1.