Denali MA11110 Quick Start Manual

Plow mount polaris sportsman

Thank you for purchasing our DENALI plow mount. You now own a premium custom

plow mount to allow you to use your plow with your ATV. Please note the following

instructions and heed all warnings.

• Your ATV and/or plow system can cause death or injury, please use caution and

common sense when operating your unit.

• Read your Plow Operator Manual, your Winch Operator Manual, and all warning

labels before operating your ATV.

• Operate your ATV at a walking speed with the blade installed. Do not exceed 5

mph (8 km/h), even with the blade up.

• Do not operate the ATV on slopes greater than 10 degrees with the plow

installed.

• Always lower the plow to the down position before leaving your ATV unattended.

SEVERE INJURY OR DEATH MAY RESULT IF YOU ARE NEGLIGENT.

866.527.7637

DENALI Plow Mount

MA11110

Polaris Sportsman

motoinfo@motoalliance.com

Table of Contents

Need help?

Do you have a question about the MA11110 and is the answer not in the manual?

Page 1 DENALI Plow Mount MA11110 Polaris Sportsman Thank you for purchasing our DENALI plow mount. You now own a premium custom plow mount to allow you to use your plow with your ATV. Please note the following instructions and heed all warnings.
Page 2 Please verify that all hardware and parts are included in your package. Kit Contents: Item Number Description Quantity Base Plate MA11110 Rear Strap 2 ¼” Serrated Hex Bolt (92323A563) 3/8” x 1” Serrated Hex Bolt (92323A554) 3/8” Serrated Flange Nut (95922A130) 866.527.7637 motoinfo@motoalliance.com...
Page 3 Polaris Sportsman MA11110 22000 Industrial Blvd Rogers, MN 55374 866.527.7637 Plow Mount Assembly: 1. Insert the Rear Strap over the Sportsman 1000 frame, just behind the Drive Shaft U- Joints as shown in Figure 2. Orient the Rear Strap so that the angled bends match the angles of the frame.
Page 4 Polaris Sportsman MA11110 22000 Industrial Blvd Rogers, MN 55374 866.527.7637 2. Hold the Plow Base Plate up to the Rear Strap to align all five bolt holes. Insert the 3/8’’ x 2-1/4’’ Serrated Flange Bolt into the middle hole at the top of the Rear Strap.