Oster POGYME3703M Instruction Manual page 30

14. Memory function
1. Press "0/MEMORY" to select memory setting, function 1 to 3.
2. If the setting has been programmed, press "START/+30SEC" to use it. If not, continue until
the configuration is chosen. Only 1 or 2 attempts are allowed.
3. After completing the setting, pressing
standby mode. Pressing "START/+30SEC" again will save the setting and start cooking.
19. Función Inquisitiva
Note: Menu auto cooking cannot be set as a memory function.
Example: to program the following setting as the second memory for cooking food with 80%
of the oven power for 3 minutes and 20 seconds
The steps are as follows:
1. In waiting states, press "
2.Press "
TIME COOK
3. Press " POWER " once, "PL10" displays, then press "8" and "PL8" displays.
START/+30SEC.
4. Press "
display "2". If you press "
memory 2 and operated.
5. If the electricity is not cut off, the procedure will be saved all the time. If it is, the
procedure need to reset.
6. If you want to run the saved procedure, in waiting state, press "
screen displays "2" , then press "
15. Multi Phase Cooking
A maximum of 2 programs can be selected for cooking. In multi-stage cooking, if one stage
is defrosting, then defrosting will automatically switch to the first stage.
Note: Auto Cooking will not work in Multi-Stage cooking.
Example: to thaw 10 oz. of beef first and then cook with 80% microwave power for 7 minutes.
(1) Press "WEIGHT DEFROST" once to select the defrost by weight function. The "dEF1" function will
be displayed.
(2) Press "1", "0" in sequence to set the weight.
(3) Press "TIME COOK" once, then press "7", "0", "0" to set the cooking time;
(4) Press "POWER" once, then press "8" to select 80% microwave power.
(5) Press START/+30SEC. to start cooking.
When defrosting is complete, the buzzer sounds once, then the second stage begins.
Note: (1) The Auto menu cannot be set as one of the 2 stages.
(2) Time defrost can be set as one of the stages.
"START/+30SEC"
0/MEMORY
" twice, stop pressing until the screen displays "2".
" once, then press "3", "2", "0" in order.
" to save the setting. Buzzer sounds once and the screen will
START/+30SEC.
START/+30SEC.
E ng li s h -12
once to save the setting will return to the
" again, the procedure will be saved as the
" to run .
" twice,
0/MEMORY