Table of Contents
Advertisement
Transmitter
EVK S
ETUP
Connect the 5V power source via a micro-USB cable from the power supply to the EVK. Be sure to use at
least a 10W power supply, to be able to supply any WPC compliant receiver.
After a few seconds, the EVK is ready to use. The LED will remain off while the EVK is searching for valid
receivers. When a valid WPC receiver is placed on the charge pad and power transfer begins, the LED
turns green. Whenever the green LED is on, the receiver is being charged. The LED behavior is
1
configurable.
The receiver may be removed at any time and charging will stop within a few seconds.
1
For information on how to configure the LED, dead-time and FOD thresholds see the section on resistor
configuration later in this guide.
© 2014 Copyright, Active-Semi International, Inc.
No portion of this document may be reproduced or reused in any form without Active-Semi's prior written consent
PAC5220WP A11 WPC
Power Application Controller
- 17
-
Rev 1.7 May, 2014
Advertisement
Table of Contents
