Advertisement
Available languages
Available languages
Installation Instructions – U-Bracket
Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance.
1:
Remove the existing luminaire (if present) and dispose of per local requirements.
2:
Remove clear knockout from back of fixture to gain access to dip switches. Dip switches are used to change wattage, color temperature, and to enable/disable
3:
photocell. (Figure 1)
Adjust dip switch position for desired setting. (Figure 2)
4:
Reinstall clear knockout cover from Step 3.
5:
Mount fixture to appropriate surface using proper hardware (supplied by others).
6:
Connect the supply wires to junction box, or similar, as shown in wiring diagram below.
7:
NOTE: The correct polarity of the dimming connections is essential to proper operation.
NOTE: If not using the dimming functionality, insulate the Dim(+) (purple) and Dim(-) (pink) wires separately (bare wires should not be left exposed). DO NOT
connect the Driver Dim(+) (purple) to the Driver Dim(-) (pink) wire as the fixture will not operate correctly.
Loosen (2) angle adjustment screws on both sides of fixture. (5mm) (Figure 3)
8:
Set fixture to proper angle then retighten the angle adjustment screws.
9:
Power can now be restored to the system.
10:
Installation Instructions – Adjustable Slipfitter
Follow Steps 1 through 5 in above U-bracket installation instructions.
1:
Remove U-bracket by removing 2 angle adjustment screws from both sides of fixture. (5mm)
2:
Fish cable through flat mounting arm. (Figure 7)
3:
NOTE: Hole for wire should be oriented so it is offset to left and toward top of bracket.
Fish cable through rubber grommet.
4:
Remove angle adjustment screw from Adjustable Slipfitter Arm. (8mm) (Figure 4)
5:
Fish wire through first half of arm.
6:
Screw first half of arm to fixture using supplied hardware. (6mm) (Figure 5)
7:
Fish wire through second half of arm.
8:
Reconnect arm using the angle adjustment screw. Do not completely tighten.
9:
Adjust arm to desired angle then finish tightening angle adjustment screw. (Figure 6)
10:
Connect the supply wires as shown in the wiring diagram below.
11:
NOTE: The correct polarity of the dimming connections is essential to proper operation.
NOTE: If not using the dimming functionality, insulate the Dim(+) (purple) and Dim(-) (pink) wires separately (bare wires should not be left exposed). DO NOT
connect the Driver Dim(+) (purple) to the Driver Dim(-) (pink) wire as the fixture will not operate correctly
Loosen set screws on arm and slide fixture and arm over 2-3/8" OD tenon. (6mm)
12:
Tighten set screws and restore power to the system.
13:
Installation Instructions – Knuckle Mount
Follow Steps 1 through 5 in above U-bracket installation instructions.
1:
Remove U-bracket by removing 2 angle adjustment screws from both sides of fixture. (5mm)
2:
Fish cable through mounting plate. (Figure 7)
3:
Fish cable through rubber grommet.
4:
Remove angle adjustment screw from Knuckle Mount Arm.
5:
Fish wire through first half of arm. (Figure 8)
6:
Screw first half of arm to fixture using supplied hardware. (Figure 8)
7:
Fish wire through second half of arm.
8:
Reconnect arm using the angle adjustment screw. Do not completely tighten.
9:
Adjust arm to desired angle then finish tightening angle adjustment screw.
10:
Attach fixture to junction box, or similar, using supplied nut.
11:
Advertisement
