CYCLOPS Explorer Helmet Light Mounting Instructions

Use and Care:

•
Start by fully charging your new battery, do not remove until the charger light turns green.
•
During operation, If the battery runs low, do not continue to try to fire the light at the switch.
•
Battery life is increased with repetitive use.
•
Store battery with at least a 50% charge.

Turn On:

Switch between high and low:

Turn Off:

Low Power:

Switch Memory:

setting you were previous at. ;i.e. if you were on high beam when the bike was
shut off, the high beam will come back on when the bike is started again.
Do not submerge
Never Charge the Battery in a Wet or Flammable Environment
Do Not charge or use a Swollen or Damaged Battery Pack
1 | P a g e
Explorer Helmet Light
Mounting Instructions
hold down the switch for ~3 seconds.
hold down button for ~3 seconds.
The glowing green ring will turn red if there is insufficient power.
When the bike is turned off the light will stay at whatever
The Lithium Battery case is water-resistant.
The Batter case is NOT waterproof.
batteries in water or any other liquid- EXPLOSION/FIRE DANGER

BATTERY SAFETY

Do Not Leave Battery Un-Attended While Charging
Fire Risk
Dispose of battery pack
One press of the button (once light is turned on)