Name Of Each Parts - Hitachi CC41R1 Instruction Manual

MN1-6264 Rev.2

2-2. Name of each parts

The name of each part is shown in Figure 2 and the explanation for each part is listed in Table 5.
Name
Ultrasonic radiation part
Orientation mark side
Probe tip
Handle
Insertion portion
Cable
Connector
Probe cover
Caution
Do not pull, bend, twist, or apply excessive force to the cable.
The probe may malfunction due to cable disconnection.
Do not subject the ultrasonic radiation part to hard impact.
The impact may cause damage to the transducer, and that results in noise or no echo in the image.
In most cases, the ultrasonic radiation part itself is not damaged because the part is made of elastic
material.
Probe cover
Figure 2 Name of each parts
Table 5 Name of each part and its explanation
Ultrasound is radiated from this part. The electronic convex transducer is
integrated underneath this part.
The side of the orientation mark corresponds to the side of the orientation
mark on the image. See 4-2.
The probe tip is the part includes both the insertion portion and the handle.
This part is held during operation.
This part is inserted into the patient.
Cable transfers electric input/output signals.
The connector is the part which is connected to the ultrasound diagnostic
instrument.
This covers the insertion portion for preventing infection. Follow the
instructions in section 4-3.
-4-
Explanation