Page 1
僅適用於家庭使用。 For household use only. RPD-YS2 7AU 本說明書的圖示可能與實物有不同的地方,僅供參考。 Some gure in this manual may not match the real product , just for reference only.
Page 18
Read all instructions carefully before using.Hazards that may cause death,injury or property damages from misuse. Be sure of correct voltage is used and plag is well plugged in socket. Remove plug from socket for cleaning maintenance or storage. To avoid dangerous,please do not cover inlet/outlet with cloth or curtain. Poor venti- lation may cause fire.
Page 19
To prevent users and others injury or damage, please follow all the instructions below Ignoring the symbols incorrect operation can result in harm or level of damage, described in the following two categories. Improper handling may lead to serious injury or even death. WARNING CAUTION Improper handling may lead to injury or property damage.
Page 20
To prevent users and others injury or damage, please follow all the instructions below Ignoring the symbols incorrect operation can result in harm or level of damage, described in the following two categories. CAUTION Do not unplug roughly. Do not use unit near flammable gas. Pulling on the power supply cord may cause fire, If flammable gas permeates the surrounding space, short circuit or electric shock.
Page 21
Control panel Louver Air inlet Air outlet Handle Handles Front plate (left and right) Polyfoam floater Outfall (Inside the water tank) Tank cover Cord holder Drain hole Water (Continuously drainage) tank Tank handle Power cord Power plug 機 體 滿 水 除...
Page 22
Water tank full indicator Defrost indicator Key Lock Anti-mold indicator 機 體 滿 水 除 霜 防 霉 按鍵鎖 按壓3秒設定 電 源 空 氣 濕 度 運 轉 乾 衣 負離子 定時 風向 淨 化 設 定 模 式 模 式 Turns the Power ON/OFF Louver setting Air clean button...
Page 23
All indicators on the LCD Panel shown below: Frame appears around selected mode Press any button when the power is on, selected function will be displayed. Meanwhile, the LCD backlight lights up, and the backlight will automatically go off after 10 seconds. Humidity indicator (Current)- indicates the current humidity (Selection)- indicates set humidity level...
Page 24
Be sure of correct voltage is used and plug is well plugged in socket. The unit automatically detects ambient humidity, when room humidity more than RH75% and LCD backlight will light up.(Deep Blue) Press "開/關(ON/OFF)" button to start the unit and the Power and Humidity indicator light turn on. Unit operates at "ECO節能(ECO)"...
Humidity Selection Pressing the button once displays the set humidity level with the (Selection)indicator. After 4 seconds, the display returns to the current humidity display and shows the word (Current) 機 體 滿 水 除 霜 防 霉 按鍵鎖 按壓3秒設定 電...
Page 26
Key Lock setting During standby or operation, please press "按鍵鎖(Key Lock)" button for 3 seconds to active the Key Lock. When the LCD Lock lights up, the unit can’t be switched off or on and all functions are not available until the key lock has been released.
Page 28
When water tank is full(5L), the water tank full indicator will light up and flash, the unit will stop operation. Please empty water tank for operation resume. Don't immediately remove water tank when full water LED light up, until few minutes later and no water attached on the cooling system.
Continuous Drainage: Caution: Do not drain water continuously if there is a possibility unattended for long periods.
Page 30
Dust or dirt clogged filter will result in reduced dehumidification efficiency and may cause failure. Clean once every 2 weeks. (Dry the filter before reinstall)
Main unit Using a soft cloth moistened with warm water (below 40 degree) or mild detergent to wipe the unit. Clean with neutral detergent and wipe with a wet cloth. Cover with plastic bag and place the unit under a area not shone by sun and good ventilation.
Page 33
RPD-YS27AU Rated Voltage/Frequency 220-240V~ 50Hz 14.9L (26.7℃ RH60%) Rated Capacity(L/Day) 27L (30℃ RH80%) Rated Power 265W Rated current 1.25A Refrigerant & Amount R134a,350g ( 5L Shut off ) Tank Capacity 15.8 kg Net Weight 600H x 370W x 263D ( mm ) Dimension(mm) 3.An electronic copy of the user manual can be emailed to the customer if necessary,please call Shun Hing...
Page 34
Trouble shooting and Emergercy Handling Before requesting for repairs, check the following points. If any abnormalities, please turn off the unit and disconnect the power cord If the above solution can not fix the problem, please contact Shun Hing Electric Service Centre Limited for check and repair.