Download Print this page

SKYLUX Solar Mounting Instructions

Electric screen
Hide thumbs Also See for Solar:

Advertisement

Quick Links

SKYLIGHTS
EN
Skylux
®
electric screen
Solar
Mounting instructions

Advertisement

loading
Need help?

Need help?

Do you have a question about the Solar and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SKYLUX Solar

  • Page 1 SKYLIGHTS Skylux ® electric screen Solar Mounting instructions...
  • Page 2: Safety

    Safety Take the necessary and required safety precautions, such as safety nets and lifelines when installing from the outside, safety goggles, gloves, hard hat, etc. Do not step on the glass. Falling from height • When using ladders to go on the roof: - Ladder in good condition? - Set up correctly at an angle of 75°? - Secured below and on top against moving?
  • Page 3 Sharp objects • Make sure your fingers/hands are not pinched and watch out for cuts while handling skylights or barrel vaults. • Be careful where you put your hands during the installation. • Wearing cut-resistant gloves is mandatory. Ergonomics • Always lift loads correctly: bend your knees, move your feet instead of forcing your spine, lift as close to your body as possible.
  • Page 4: Table Of Contents

    Mounting instructions 105710 electric screen Solar Depending on its dimensions, the screen starts on the short or long side. Please note: the electric screen on Solar cannot be combined with opal and/or solar control glazing. Necessary tools PVC curb GRP curb Ø...
  • Page 5: Dimensions And Position Of The Electric Screen

    Please note: installing the electric screen with Solar deeper in the curb will significantly reduce the effiency of the Solar solar panel. Curb requirements: It is important that the curb and its daylight size are perpendicular and have no deformations.
  • Page 6: Installation

    (Bluetooth logo) and charging port facing downwards / inside Orientation towards the sun: The solar panel must be facing south to achieve the best efficiency. Install the electric screen with the solar panel on the north side (N). Correct:...
  • Page 7 Installing the mounting clips Position and number of mounting clips: Mounting clips must always be provided on the transversal sides of the electric screen. screen long side (L) ≤ 2000 mm X 12 clips X 12 clips X 12 clips X 12 clips X 12 clips long side (L) >...
  • Page 8 Intermediate distance X from between number # clips between between between between between between daylight size start and short of clips per side 6 - end side 400 x 400 400 x 700 400 x 1000 400 x 1300 400 x 1400 400 x 1600 400 x 1900 400 x 2200...
  • Page 9 Intermediate distance X from between number # clips between between between between between between daylight size start and short of clips per side 6 - end side 800 x 1800 800 x 2000 800 x 2200 800 x 2300 800 x 2500 800 x 2800 850 x 850 900 x 900...
  • Page 10 In case of a combination with an openable glass flat roof window: do not screw where the built-in actuators are situated. Never screw where the built-in spindle actuator is situated in the curb!! 355 mm actuator In case of a square curb: Install the electric screen with the screws of the mounting clips on the sides without actuators.
  • Page 11 Do not screw through the curb towards the outside to avoid any water infiltration from the outside. Installing the electric screen with Solar deeper in the curb will significantly reduce the effiency of the Solar solar panel. Polyester (PRV) curbs: Do not screw in the polyester curbs.
  • Page 12 Place the electric screen Optional: Depending on the play of the daylight size of the curb and the desired finish, the supplied tape can be provided around or on one or more sides of the electric screen. This also eliminates the visual play (this can be the case especially with a polyester curb and in exceptional cases with a PVC curb).
  • Page 13 Prevent the electric screen from getting blocked by the mounting clips during opening and closing. Pull the electric screen horizontally in relation to the curb: 10 mm Pull Remove the protective foil on the solar panel before the first use. 13/15 01/09/2022 E_MH_Mounting_instructions_Skylux_Electric_screen_Solar...
  • Page 14: Electrical Connection / Commissioning

    Electrical connection / commissioning In any case, charge the electric screen for 8 hours first before the installation or first use. Charge: When there is little sunlight, the electric screen with Solarpack (battery included) can be recharged again. Low battery in the Solarpack charger Charger type: USC-C to standard USB-A...
  • Page 15: Control: Switch

    Following aspects are excluded from normal use in normal climate conditions: damage of the solar panel due to overvoltage, lightning strike, water damage, vermin, fire, glass breakage, extreme shocks or similar external influences, based on actions of third parties and other events or accidents that are excluded from normal use of the solar panel and on which the manufacturer does not have any influence.