Advertisement
Advertisement
Table of Contents
Related Manuals for SKYLUX 230V
Summary of Contents for SKYLUX 230V
- Page 1 SKYLIGHTS Skylux ® electric screen 230V / Solar Mounting instructions...
-
Page 2: Safety
Safety Take the necessary and required safety precautions, such as safety nets and lifelines when installing from the outside, safety goggles, gloves, hard hat, etc. Do not step on the glass. Falling from height • When using ladders to go on the roof: - Ladder in good condition? - Set up correctly at an angle of 75°? - Secured below and on top against moving? - Page 3 Sharp objects • Make sure your fingers/hands are not pinched and watch out for cuts while handling skylights or barrel vaults. • Be careful where you put your hands during the installation. • Wearing cut-resistant gloves is mandatory. Ergonomics • Always lift loads correctly: bend your knees, move your feet instead of forcing your spine, lift as close to your body as possible.
-
Page 4: Table Of Contents
Ø 5 mm Roll of tape 2mm 78179 10 m Cuttable covering rubber 78328 for cable 50 m (optional) Bluetooth push button 77433 interface Skylux Mounting instructions 78267 inner sunblind Necessary tools Ø 9 Ø 9 Ø 5 Ø 9 230 V... -
Page 5: Dimensions Of The Inner Sunblind
Dimensions of the inner sunblind The size of the inner sunblind depends on the daylight size of the curb. daylight size roof opening Art. no. Art. no. Daylight size 230V Solar ** 60 x 60 78081 80785 2 x 2 2 x 2... - Page 6 Exceptions Do not screw in the polyester curbs. Use the rivet instead. Ø 5 Pre-drill with ø 5 mm through the inner wall. Ø 9 If you screw the bracket in the “old” 16/20 PVC curb, it’s best to screw with inclination (+10°). After screwing the clips, you take the inner sunblind and push it in the opening view from below the skylight hinge side of...
- Page 7 Make sure all springs click over the profile. Position of Solar Pack for best efficiency: click! Install the Solar Pack at least 10 mm from the edge of the curb. If not possible, install as high as possible. This affects the efficiency of the Solar Pack, which means that the Solar Pack sometimes needs to be recharged.
- Page 8 230V connection Cable fixation 1 cable fixation 2 Exception ø 9 mm ø 9 mm optional Art.No. 78328 not watertight Important info Solar Not suitable for charging appliances! USB C E_MH_Mounting_instructions_Skylux_Electric_screen 01/01/2021...
-
Page 9: Push Button
Push button The system is controlled by a wireless module that can be clicked behind the (existing) switch. A bluetooth technology ensure the connection between the wireless module and the screen (so no extra cables needed between the switch and screen). Wiring diagram Wires are connected to the external push buttons.
Need help?
Do you have a question about the 230V and is the answer not in the manual?
Questions and answers