Installation; Loose Parts - Toro 117-3600 Installation Instructions Manual

Installation

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
1
Removing the Existing Side
Discharge Chute
No Parts Required
Procedure
1. Disengage the PTO, set the parking brake, and chock
or block the drive wheels.
2. Turn off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the locknut, bolt, spring and spacer holding
the deflector to the pivot brackets (Figure 1).
Remove the grass deflector.
Description
No parts required
Side discharge chute
Bolt, (5/16 x 7–1/2 inches)
Locknut, (5/16 inch)
Plastic spacer
Spring
Handle assembly
Bolt, (3/8 x 1 inch) (Self tapping)
Plastic cable tie
Handle assembly
Bolt, (3/8 x 1 inch)
Plastic cable tie
Adhesive back mount
Trash bag
International decal
Qty.
Remove the existing side discharge
–
chute.
1
1
Install the side discharge chute with
1
gate.
1
1
1
Install the handle to a GrandStand
2
Mower.
1
1
2
Install the handle to a Z Master G3
Mower.
1
1
1 Install the trash bag.
Install the decal for international mowers
1
only.
1. Bolt
2. Spacer
3. Locknut
4. Spring
2
Use
Figure 1
5. Spring installed
6. Grass Deflector
7. L end of spring, place
behind deck edge before
installing bolt
8. J hook end of spring