Advertisement
Quick Links
LS4
Quick Start Guide
Meet the new Leak Sensor from NextCentury. The Leak Sensor is capable
of detecting water and sending audible alerts in addition to cloud-managed
alerts and notifications. The Leak Sensor's wireless communication is
built on the industry-leading NextCentury Connect™ network and is
compatible with the full family of NextCentury wireless devices.
Installation Components
A
Leak Sensor
B
A) LS4 Leak Sensor
B) Mounting Plate
C) Sheetrock Anchors and Screws
D) Water Sensing Cables
Additional Resources
C
For full installation guide, spec sheets, and additional
resources, please visit:
products.nextcenturymeters.com/ls4
Contact Information
Phone: 844.538.8203 opt. 2
Email: support@nextcenturymeters.com
D
Targeted Cable
or
Rope Cable
Advertisement
Related Manuals for NextCentury LS4
Summary of Contents for NextCentury LS4
- Page 1 Quick Start Guide Meet the new Leak Sensor from NextCentury. The Leak Sensor is capable of detecting water and sending audible alerts in addition to cloud-managed alerts and notifications. The Leak Sensor’s wireless communication is built on the industry-leading NextCentury Connect™ network and is compatible with the full family of NextCentury wireless devices.
- Page 2 Installa'on Common Leak Locations The Leak Sensor can provide alerting when water is detected in any leak-prone location. Mount and Connect Install the Leak Sensor close to where you would like to detect a leak. Select a dry location that is accessible for inspection and future battery replacement.
- Page 3 Water Sensing Cables Water sensing Rope Cables or Targeted Cables are installed in the area where you would like water to be detected. Up to 3 cables can be daisy- chained together expanding the leak detection area. Targeted Cable The Targeted Cable can detect standing water at a single point. It can be installed at the base of a wall or on the floor.
- Page 4 Cloud Connected Wireless Made Easy When installing NextCentury Sensors, you can instantly know if everything is working correctly by tapping the red Test Connect button. The Leak Sensor’s RF LED will blink green when it is able to communicate with the property Gateway.