Advertisement
8.Disassembling of the switch box
Switch box cover
Slightly bend the switch lever and then remove the switch lever from the handle.
Loosen the tapping screw flange PT4x18(4 pieces), and remove the switch box and switch box cover from the
handle.
Caution : Use care not to miss the compression spring 16 as it may potentially jump out.
Sinwasher
E ring 12
Spring pin 3-28
Switch lever arm
witch box
Tapping screw flange PT4x18
Lever
Insert the spring pin 3-28 in the direction
shown on the figure and then mount the inlet
cover.
Switch lever
Remove
with bending.
Disconnect the E ring 12 to remove the
15, lever and switch
lever arm etc.
Handle
Advertisement
