Advertisement
Remove the front shaft and rear shaft from the deck.
<Cautions in assembling>
Assemble the shorter side of the
connecting rod on the front shaft.
For the tension spring 12, first assemble the connecting rod side
and then insert the hook at back side into the root of boss on the deck.
7.Disassembling of the control panel
Caulking(5 points)
O.C.R.
Loosen the tapping screw flange PT4x12(2 pieces) to remove the claws at 6 points, and then disassemble the
control panel and control panel holder.
To disassemble the inlet, cut off the lead wire.
<Cautions in assembling>
Assemble the switch while the switch lever is being turned off.
Use care of directions for up/down when assembling the indicator.
Assemble the O.C.R. while the face with 5 caulking faced up.
How to assemble the inlet cover
Hole
Control panel(main side)
Connecting rod
Cap
Hexagon nut M12
Indicator
Torsion spring 4
Front shaft side
Boss
Control panel
Claw(6 pieces)
Inlet
Control panel holder
Tapping screw flange PT4x12(2 pieces)
Switch
Inlet cover
Short
Insert into the root.
Switch plate
Set the torsion spring 4 on the inlet
cover as shown on the figure and
then insert the longer arm of the
torsion spring 4 through the hole of
control panel.
Boss
Advertisement
