Method 2 (This method may reduce the accuracy of the machine)
1. Remove the base part of the machine.
2. Drill 16 holes with 7mm diameter on the table according to the location of the holes on the machine.
3. Prepare 16 pieces of M5 screws, 16 pieces of M5 flat washer, 16 pieces of M5 nuts. The length of the screws depends
on the thickness of your table.
4. Insert M5 screws through the holes in the machine and table, add spacers and secured with nuts to the exposed bolts
at the bottom of table respectively.
(16) 7mm Through Holes
Machine mount
M5 Bolt
17