Table of Contents
Advertisement
Available languages
Available languages
Changing the batteries
When the batteries are running low, the pool light will flash red. Unscrew the
lower housing shell by turning it counter clockwise and replace the used LR6
(AA), 1,5 V batteries with three new ones of the same size and type. Do not mix
batteries of different types and charge levels and do not mix batteries and
rechargeable batteries. Pay attention to the correct polarity, polarity symbols
are located in the battery compartment. Then screw the housing shells hand-
tight again.
Change the battery in the remote control by unlocking and pulling out the
drawer on the remote control. Replace the CR2025 battery with a new one.
The positive pole must be on the side facing away from the keypad.
Cleaning
▪
Wipe the housing of the device with a lightly moistened cloth. Use detergent
as needed.
▪
Do not immerse the remote control in liquids of any kind.
▪
Do not clean the device with aggressive chemicals or abrasives in order not
to damage the surfaces.
Technical Data
LED:
Timer Functions:
Remote Control Range:
Remote Control Frequency: 433,92 MHz
Dimensions:
Weight:
Degree of Protection:
Batteries:
Illumination Time:
13x RGB LED
2, 4, 6 h
30 m in air, 1,5 m in water
Ø 8,5 x 3,5 cm
136 g
IP68 (max. 1 m)
3x 1,5 V, LR6, (AA)
3 V CR2025 (remote control)
Up to 50 h
9
Advertisement
Table of Contents
