GSL electronics RBC-12-NG Installation & Operating Instructions

Models:
RBC-12-NG & RBC-24-NG
Page 1 of 4
(Standard installation)
GSL's RBC range is a new generation of brake controllers that operate in a pre-set braking force utilising microprocessor technology.
Available in both 12V and 24V, GSL's RBC range eliminates the need for a separate reducer on 24V systems. This new generation of brake
controllers has been designed for both single and dual axle trailers using a negative earth (ground) systems only.
Rugged and compact, it is easily installed with the simple connection of four wires and comes with a remote control. The remote control is
simple to install and makes adjusting and monitoring the brakes even easier. This remote control can be located up to 1m from the brake
controller. Both the 12V and 24V models also incorporate an override function for independent braking of the trailer from the vehicle brakes -
helping to prevent potentially dangerous swaying and snaking.
1 x Remote brake controller
1 x Retaining nut (on unit)
1 x Washer (on unit)
1 x Remote control
1 x Dash mount decal
Page 1 of 4
Installation & Operating Instructions
Please read these instructions before use
Unit 2, 110 Station Road, Seven Hills ,NSW, 2147, Australia
More information https://www.caravansplus.com.au
RBC-12-NG
RBC-12-NG RBC-24-NG
9 VDC 18 VDC
12 VDC 24 VDC
15 VDC 30 VDC
Yes Yes
30 mA
2 Axle / 12A Avg
30mm x 57mm x 90mm
200g
RBCNG-R2