Troubleshooting; Warranty Card - iHealth Lite Owner's Manual

Sauna continually beeps when turned on Ensure the temp sensor cable is plugged into the correct input in

Warranty Card

TO REGISTER YOUR iHEALTH SAUNAS TO RECEIVE THE FULL
WARRANTY, PLEASE ENTER THE FOLLOWING INFORMATION AND
POST TO iHEALTH SAUNAS, 29/137-145 ROOKS ROAD, VERMONT VIC 3133
WITHIN 14 DAYS FROM THE DATE OF INSTALLATION.
Serial Number:
First Name:
Address:
Suburb:
Phone No:
Email:
14
Problems Please Ensure
Sauna not turning on Power point sauna is connected to is operational
White (lume) wire from control panel is connected into the correct
outlet on control box. See page 30
Temperature Check the temperature sett ing on the control panel and reset if
required. Refer to page 32 for instructions.
Check the temperature sensor cable is connected to the control box
in the roof and the head is visible inside the sauna. Unscrew plate in
roof and pull sensor head down slightly. Reatt ach plate.
Lights not turning on Light 1 and Light 2 butt ons are pressed aft er power butt on on sauna
is pressed. See Page 32
Light connectors are plugged in correct outlet on control box. See
page 30
Sauna not heating Sauna on/off butt on pressed for a second time aft er sauna is turned
on initially
There is 'time' in the time display on the control panel. See page 32
All 4 heater cables are connected correctly into control box. See
page 30
The Auto function (middle light) is turned off
control box. See page 30

Troubleshooting

Purchase Date:
Last Name:
State, Postcode:
Mobile: