LG PF510Q Owner's Manual page 51

8
Cautions for Network Setup
• Use standard LAN cable (connect to Cat7 or higher with RJ45 connector, 10
Base-T, or 100 Base TX LAN port).
•
Resetting the router may fix some network connection problems. Turn the
power OFF, disconnect and reconnect it, and then turn the power on to solve the
problem.
•
LG Electronics is not responsible for network connectivity or operation failure
due to problems such as equipment failure or disconnected lines.
• The network connection may not work properly because of network settings or
the Internet service provider.
•
DSL service must use a DSL modem; and cable service must use a cable modem.
Since only a limited number of network connections may be available, projector
network setting may not be used depending on the contract with Internet
service provider. (If the contract does not allow more than one device per line,
only the already-connected PC may be used.)
•
A wireless network can experience interference from other devices that use
the 2.4 GHz frequency (wireless phone, Bluetooth device, or microwave oven).
Although interference can also happen when using the 5 GHz frequency, it is less
likely to occur.
• The wireless environment can make wireless network service run slowly.
• Using several wireless devices at the same time can slow your network.
•
The access point device must support wireless connections and wireless
connection feature must be enabled on the device to have AP (access point)
connection. Contact the service provider for availability of wireless connections
on the access point.
• Check SSID and security settings of the AP. Refer to the appropriate
documentation for SSID and security settings of the AP.
•
If the network is changed by moving the projector or changing the router, you
must set up the wireless network again. Existing wireless network connections
will not be saved.
•
Invalid settings of network devices (wired/wireless line sharer, hub) can cause the
projector to operate slowly or not operate properly. Install the devices correctly
according to the appropriate manual and network.
• The connection method may differ depending on the AP manufacturer.
•
To troubleshoot problems with this feature, refer to "TROUBLESHOOTING".