AEG LR63142 User Manual page 24

24 www.aeg.com
3. If desired, set one or more options by
touching the related buttons. The
related indicators come on in the
display and the given information
changes accordingly.
In case a selection is not
possible, no indicator
comes on and an acoustic
signal sounds.
12.6 Starting a programme
with the delay start
1. Touch this repeatedly until the
display shows the desired delay time.
The indicator
2. Touch the Start/Pauze button.
The appliance starts the countdown of
the delay start.
When the countdown is completed, the
programme starts.
The ProSense estimation
starts at the end of the
countdown.
Cancelling the delay start
after the countdown has
started
To cancel the delay start:
1. Touch the Start/Pauze button to
pause the appliance. The related
indicator flashes.
2. Touch the Startuitstel button
repeatedly until the display shows
3. Touch the Start/Pauze button again
to start the programme immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start/Pauze button to
pause the appliance. The related
indicator flashes.
2. Touch the Startuitstel button
repeatedly until the display shows the
desired delay time.
3. Touch the Start/Pauze button again
to start the new countdown.
comes on.
.
12.7 Starting a programme
Touch the Start/Pauze button to start the
programme.
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
12.8 The ProSense
Technology load detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Start/Pauze button,
the maximum declared load indicator
goes off, the indicator
ProSense Technology starts the laundry
load detection:
1. The appliance detects the load in the
first 30 seconds, the indicator
flashes, the drum rotates shortly.
2. At the end of the load detection, the
indicator stop flashing. The
programme duration will be adjusted
accordingly and could increase or
decrease. After further 30 seconds,
the water filling starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display.
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pauze button to start the
programme again. The ProSense
Technology phase can be repeated up to
three times (see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
flashes, the
is