Table of Contents
Advertisement
Fault
"E:36 / -10"
"E:36 / -25 / -26"
flashes.
flashes.
lights up.
flashes.
All other error codes.
Malfunctions
Fault
The appliance is not work-
ing.
Cause
Unapproved extension in-
stalled on the water drain
hose.
Drain pump is blocked.
The water pressure is low.
The filters in the water inflow
are blocked.
The tap is turned off.
The water inlet hose is
kinked or jammed.
The automatic voltage con-
trol system detects an unau-
thorised voltage under-us-
age.
Voltage under-usage causes
a programme extension.
The temperature is too high.
Water level is too high.
Laundry is caught in the
door.
Door is not closed.
Malfunction
Cause
The mains plug of the power
cord is not plugged in.
Troubleshooting en
Troubleshooting
Remove any unapproved exten-
▶
sions from the water hose.
→ "Connecting the appliance",
Page 17
→ "Cleaning the drain pump",
▶
Page 43
No remedial action possible.
"Clean the filters in the water in-
▶
flow" → Page 46.
Turn on the tap.
▶
Ensure that the water inlet hose is
▶
not kinked or jammed.
No remedial action possible.
▶
Note: If the power supply is stable, the
programme continues to run as nor-
mal.
No remedial action possible.
Wait until the temperature has
▶
dropped.
→ "Cancelling the programme",
▶
Page 38
Start the
programme.
▶
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press inicio pausa + carga to start
4.
the programme.
Close the door.
1.
Press inicio pausa + carga to start
2.
the programme.
Call the after-sales service.
▶
→ "Customer Service", Page 58
Troubleshooting
Connect the appliance to the power
▶
supply.
49
Advertisement
Table of Contents
