Kraus FC-100 Installation Manual
Kraus FC-100 Installation Manual

Kraus FC-100 Installation Manual

Replacement filter cartridges

Advertisement

R
INSTALLATION MANUAL
Replacement Filter
Cartridges
FC-100
www.kraususa.com
I
Toll Free: 1.800.775.0703
I
© 2021 Kraus USA Plumbing LLC
I
REV. September 2, 2021

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FC-100 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Kraus FC-100

  • Page 1 INSTALLATION MANUAL Replacement Filter Cartridges FC-100 www.kraususa.com Toll Free: 1.800.775.0703 © 2021 Kraus USA Plumbing LLC REV. September 2, 2021...
  • Page 2 Congratulations on the purchase of your new Kraus plumbing fixture! Please keep the box and packaging materials until your product is completely installed. If you have any questions, require technical assistance or have any problems with your product: STOP DO NOT RETURN TO STORE Please contact our Customer Service Team 1-800-775-0703 / customerservice@kraususa.com...
  • Page 3: Prior To Installation

    Prior to Installation: · Make sure you have all necessary parts by checking the diagram and parts list. If any part is missing or damaged, please contact Kraus Customer Service at 800-775-0703 for a replacement. · Replace the filter cartridges every 6 months or when the 700 gallon capacity has been exceeded, whichever comes first.
  • Page 4: Specifications

    Diagram and Parts List Polypropylene Cartridge Compressed Carbon Cartridge Specifications Flow Rate 0.7GPM NOTE: Depending on local water quality and use environment, the actual filtered water flow rate and total filtered water volume will vary. Rated Daily Production Rate: 1007GPD Min static pressure: 40 psi (275.8 kPa) Max static pressure: 120 psi (827.4 kPa) Inlet Water Temperature 41°...
  • Page 5 Step 1. Remove the existing filter cartridge. Place a bucket under the filtration system to catch any dripping water. Rotate the cartridge 90° clockwise and pull down to remove. Throw out the used cartridge.
  • Page 6 Step 2. Install the filter cartridges. Write the date on the new filter cartridge label. Remove the cap from the filter cartridge and discard. Inspect the O-rings cartridge for any damage. Make sure both sets of O-rings are present and are positioned correctly.
  • Page 7 Step 4. Display & Reset: After installing new filters push and hold the settings button for 3 seconds. Filter 1 icon will blink. Push the reset button and hold for 3 seconds and the icon will reset to full capacity. Push the settings button again and filter 2 icon will blink.
  • Page 8: Troubleshooting

    Troubleshooting If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective steps: PROBLEM CAUSE ACTION Water leaks between the An O-ring is damaged, dirty, or Turn off the water supply, and relieve filter head and the filter cartridge.
  • Page 9: Replacement Parts

    Replacement Parts Replacement Parts List Part # 1. Compressed Carbon Cartridge KF-1CB 2. Polypropylene Cartridge KF-1PP...
  • Page 10 System conforms to NSF/ANSI 42 , 53 and 401 for the specific performance claims as verified and substantiated by test data. While testing was performed under standard laboratory conditions, actual performance may vary. Download the Kraus Care & Maintenance Guide at: http://www.kraususa.com/maintenance...
  • Page 11 IMPORTANT Register Your Kraus Product Activate Your Warranty Access Premium Customer Support Get Product Information REGISTER TODAY http://www.kraususa.com/registration www.kraususa.com...

Table of Contents