Husqvarna TE125 2012 Specification And Operation Manual page 73

REmoviNg thE fRoNt whEEl
Set a stand or a block under the engine and see that the
front wheel is lifted from the ground.
loosen the bolts (1) holding the wheel axle (2) to the
front fork mounts. hold the head of the wheel axle in
place, and unscrew the bolt (3) on the opposite side;
draw the wheel axle out.
Note *:
Do not operate the front brake lever when the wheel has
been removed; this causes the calliper pistons to move
outwards. After removal, lay down the wheel with brake
disc on top.
REASSEmbliNg thE fRoNt whEEl
fit the l.h. spacer (D) on the wheel hub.
fit the wheel between the fork legs so as to set the brake
disc into the calliper.
fit the wheel axle (2) from the R.h. side, after greasing
it and push it fully home against the l.h. fork leg; during
this operation, the wheel should be turned. tighten the
screw (3) on the fork l.h. side but Do Not lock it.
Now, pump for a while, pushing the handlebar down-
wards until you are sure that the fork legs are perfectly
aligned. lock: the screws (1) on the R.h. leg the screw (3)
on the l.h. side, the screws (1) on the l.h. leg.
1
2
SPECIFICATIONS - OPERATION - MAINTENANCE
Note *:
After reassembly, pull the brake control lever until the
pads are against the brake disc.
1
3
EN - 31