Table of Contents
Advertisement
Turn both locking levers towards
3.
each other.
Remove the top cap from the heat
4.
exchanger.
Remove the heat exchanger.
5.
Flush water through the heat
6.
exchanger from all sides to
completely remove all fluff.
Caution!
There is a risk of damage to the heat
exchanger.
Only use water to clean the heat
exchanger, and do not use any hard
objects or objects with sharp edges
to remove the fluff.
Remove all fluff from the seals on
7.
the dryer and on the heat exchanger.
Allow all the water to drip off.
8.
First insert the heat exchanger, and
9.
then fit the heat exchanger's top cap
in place.
Turn both locking levers back and
10.
close the maintenance flap until it
locks into place.
Close the maintenance flap and
11.
press on it until you feel it click in
place.
Cleaning
en
33
Advertisement
Table of Contents
