YATO YG-03100 Instruction Manual page 9

GB
PRODUCT OVERVIEW
Electric vegetable cutter is used for fast and effi cient cutting of vegetables. Thanks to its removable blade discs it is possible to
obtain various types of cuts tailored to the user's needs. Two inlets ensure effi cient and safe operation. The correct, reliable and
safe operation of the appliance depends on its proper use therefore:
Before the fi rst use of the product read and keep the entire manual.
The supplier will not be held liable for any damage resulting from failure to observe the safety regulations and recommendations
specifi ed in this manual.
ACCESSORIES
The delivered product is complete but requires a number of preliminary actions described further in the manual.
SAFETY INSTRUCTIONS
Caution! Read all of the following instructions. Failure to do so may result in an electric shock, fi re or personal injury.
FOLLOW THE INSTRUCTIONS BELOW
The product is intended only for vegetable cutting. Do not cut other food products. Do not cut frozen products.
Do not use the product in an explosive environment containing fl ammable liquids, gases or vapours.
The product should be set on fl at, even, and hard surfaces. Do not place the product near heat or fi re sources. Position the product
so as to ensure proper ventilation around it. Do not cover the ventilation openings in the product housing. Maintain a distance of
10 cm around the product. Ensure enough room over the product to enable its free operation. Place the product so as to allow
easy access to the electrical outlet to which the its power cord plug is inserted. The placement should also provide free access
to the electrical switch.
Connect the product only to a power network providing the voltage and frequency indicated on the nameplate of the appliance.
The plug of the power cord must match the power socket. Do not modify the plug. Do not use any adapters to fi t the plug to the
socket. If unmodifi ed, the plug matches the socket thus reducing the risk of an electric shock.
After each application, unplug the power cord from the power socket.
Avoid direct contact with grounded surfaces such as piping, radiators and refrigerators. Grounding of the body increases the risk
of electrocution.
The product is intended for indoor use only. Do not expose the product to any precipitation or moisture. If water and moisture
enters the product, the risk of an electric shock is signifi cantly increased. Do not immerse the product in water or any other liquid.
Do not overload the power cord. Do not use the power cord to carry the product, connect, or disconnect the plug from the power
socket. Avoid any contact between the power cord and heat sources, oil, sharp edges or moving parts. Damage to the power cord
increases the risk of an electric shock. If the power cord is damaged (e.g. it is cut or its insulation is melted), immediately unplug
it from the wall socket and return it to an authorised service facility. NEVER use the product if its power cord is damaged. NEVER
repair the power cord. It must be replaced with a new one at an authorised service centre. The product must be connected directly
to a single socket of the power network. It is forbidden to use extension cords, adapters or double sockets. The mains supply
circuit must be fi tted with a protective conductor and a 16 A protective device.
Should any signs of damage to any part of the product be visible, stop using it. In this case, the product must be taken to an
authorised service centre.
The cutting discs are fi tted with very sharp blades. Special care must be taken when operating and maintaining the cutting discs.
Due to the risk of injury, protective gloves should be worn during operation and maintenance of the cutting discs.
Use only cutting discs and other accessories supplied with the product or original accessories and spare parts provided by the
manufacturer. It is not allowed to modify the mount to match the cutting disc to the spindle.
The product is not to be used by children. This product cannot be used by people with impaired physical and/or mental abilities, or
by people without experience in or understanding of the operation of the product, unless they are supervised or instructed in the
safe use of the product, so that they understand the relevant operating risks. Children should not play with the product. Children
should not be allowed to clean or maintain the product without the supervision of an adult.
PRODUCT OPERATION
Preparing for operation
The product must be unpacked and all parts of the packaging completely removed.
Caution! Some cutting discs may be protected with foil, so before the fi rst use it should be removed completely.
It is recommended to keep the packaging, as it can be helpful for further transport and storage of the product.
Check the product for damage. If any damage is detected, do not use the product until the damage has been repaired or the
O R I G I N A L I N S T R U C T I O N S
9