GETTING STARTED
Exit Try-Me Mode:
The product is in try-me mode in the packaging. To exit try-me
mode, just slide the "Off/Dino Mode/Vehicle Mode" Switch from
Vehicle mode to Dino mode.
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the unit. Use a screwdriver
to loosen the screw, and then open the
battery cover.
3. Remove the old battery by pulling up on
one end of the battery.
4. Install 1 new AAA battery following the
diagram inside the battery box. (For best
performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries
are recommended.)
5. Replace the battery cover and tighten
the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
4
Need help?
Do you have a question about the SWITCH&GO HATCH & ROAAAR EGG PTERODACTYL CHOPPER and is the answer not in the manual?