ulsonix AIRCLEAN 40G User Manual page 3

EN
e) In case of open flames or fire, use only dry powder or
snow (CO2) fire extinguishers to extinguish the live
equipment.
f) No children or unauthorized persons are allowed
in the work area. (Inattention may result in loss of
control of the unit.)
g) Check the condition of the safety stickers regularly.
Replace them if they are illegible.
h) Keep these instructions for use for future reference.
If the product is to be handed over to a third party,
hand it over with this user manual.
i) Keep the device away from children and animals.
j) The room to be ozonated should be sealed (close the
external doors, eliminate leaks in windows, doors,
etc.), with mechanical ventilation turned odd and
vents covered. If possible, it is recommended to turn
on internal ventilation to facilitate the circulation of
air in the ozonated room. Open the interior door (e.g.
bathroom, wardrobe, etc.) in the ozonated room.
k) It is forbidden for people or animals to stay in the
room where the ozonation treatment is carried out.
If it is necessary to enter the room, keep the time
spent in the room to a minimum and use protective
clothing and masks with an appropriate insert.
l) In the room where the ozone treatment is carried
out, it is forbidden to smoke, work with open fire,
work with tools that flame or spark, work with oils
and greases or leave objects dirty with oil or grease.
m) After turning on the ozonation machine, leave the
room immediately.
REMEMBER! When using the device, protect children
and other bystanders.
2.3. PERSONAL SAFETY
a) Do not operate this device if you are tired, ill or under
the influence of alcohol, drugs or medication that
could impair your ability to operate the device.
b) The device is not intended to be used by persons
(including children) with reduced mental, sensory or
intellectual functions or persons who lack experience
and/or knowledge unless they are supervised or
have been instructed by a person responsible for
their safety on how to operate the device.
c) The unit may be operated by persons who
are physically fit, capable of operating it and
appropriately trained, and who have read this
instruction manual and have been trained in
occupational safety and health.
d) Use caution and common sense when operating this
unit. A moment's inattention during operation may
result in serious personal injury.
e) To prevent accidental start-up, make sure the switch
is in the off position before connecting to a power
source.
f) The product is not a toy. Children should be watched
to ensure that they do not play with the appliance.
2.4. SAFE USE OF THE UNIT
a) Do not use the unit if the ON/OFF switch does not
function properly (does not turn on and off). Units
that cannot be controlled by the switch are unsafe,
cannot operate, and must be repaired.
b) Unplug the unit before making adjustments,
changing accessories, or putting it away. This
precaution reduces the risk of accidental start-up.
4 4
c) Keep unused product out of the reach of children
and anyone unfamiliar with the device or this manual.
Products are dangerous when used by inexperienced
users.
d) Keep the product in good working order. Check
before each use for general damage or damage to
moving parts (cracks in parts and components or any
other condition that may affect the safe operation
of the device). If damaged, have the device repaired
before use.
e) Keep the product out of the reach of children.
f) Repairs and maintenance should be carried out by
qualified personnel using only original spare parts.
This will ensure the safety of use.
g) To ensure the designed operational integrity of the
device, do not remove factory-installed covers or
loosen screws.
h) When transporting or moving the unit from storage
to the place of use, observe the health and safety
rules for manual handling applicable in the country
where the unit is used.
i) Do not move, shift, or rotate the machine while in
operation.
j) Clean the device regularly to prevent permanent dirt
build-up.
k) Do not obstruct the air inlet or outlet.
l) The product is not a toy. Cleaning and maintenance
must not be performed by children without adult
supervision.
m) Do not tamper with the device to alter its
performance or design.
n) Keep the unit away from sources of fire and heat.
o) Do not overload the device.
p) Do not allow persons with impaired sense of smell to
operate the unit.
q) Make sure there is enough space around the device
before it is turned on
r) Directly inhaling the ozone discharged from the
unit's outlets is STRICTLY FORBIDDEN. Short-term
inhalation of high ozone concentrations and long-
term inhalation of low ozone concentrations can be
dangerous to health and even life!
ATTENTION! Despite the safe design of the device
and its protective features, and despite the use of
additional elements protecting the operator, there is
still a slight risk of accident or injury when using the
device. Stay alert and use common sense when using
the device.
3. INSTRUCTIONS FOR USE
The device is used to generate ozone from the surrounding
air and is used for disinfecting rooms.
The user is responsible for any damage resulting from
misuse.
3.1. PRODUCT OVERVIEW
A
B
C
D
E
A. Transport handle
B. Crossbar connecting the handle to the housing
C. Casing
D. Outlets
E. Foot
F. Control panel with display
G. Inlet opening
H. Castor
I. Pocket for power cord + fuse holder (inside)
J. Remote control (photo below)
3.2. PREPARATION FOR OPERATION
POSITIONING OF THE UNIT
The ambient temperature must not exceed 40°C and
ambient humidity should not exceed 85%. Place the unit
in the middle of the room in a way that ensures good air
circulation. Maintain a minimum clearance of 10 cm from
any wall of the unit. Keep the unit away from any hot
surfaces. Always operate the unit on a level, stable, clean,
fireproof and dry surface and out of the reach of children
and persons of impaired mental, sensory and intellectual
functions. Place the unit in such a way that the mains
plug can be reached at any time. Ensure that the power
supply to the unit corresponds to that specified on the
identification plate!
5 5
EN
ASSEMBLY OF THE UNIT
F
G
Using the 6 screws and the Allen key (picture above), attach
the transport handle (a) with both crossbars (b) to the
H
housing of the device (c) as shown in the diagram below:
b
c
I
a
a
b
b
c
3.3. WORKING WITH THE DEVICE
5 6
10
8 7 9
3
4
1
2