Operating The Device; Maintenance And Cleaning - Crown EXO-20 Manual

35cm
15cm
BODY HOLDER
Min. 1.80m
WALL HOLDER
PLASTIC HEAD SCREW
WINGNUT
ALLEN SCREW
Fig. 2
Electric Connection
Insert the plug into the socket by paying attention to the "L" and "N" mark, connect it to
a grounded socket for your safety, then straighten the heater upwards, find the best
angle and tighten the screws.

Operating the Device:

• To operate the device, plug the power cord into the socket, turn the thermostat
button to min. or max. to set the ambient temperature to the desired level. Unplug the
power cord to turn off the device.
• To benefit from the device at the optimum level, make sure that it is mounted in the
right place and operated in suitable ambients.
• If the device is used indoors, do not face the heating area to open areas such as
windows and balconies. In case the device is not used for a long time or being
relocated, make sure that the power cord is unplugged and the heater is cold.

Maintenance and Cleaning:

• Before starting to clean your device, turn off the device, unplug the power cord for
safety and wait for the device to cool down.
• The outer surface of the device should be cleaned with a soft, cotton, slightly damp
cloth or a soft brush.
•Never use abrasives or solvents to clean the heater.
• Do not clean the product with substances such as gasoline, thinner solvent, etc. that
will corrode or damage the product.
•These substances can damage plastic parts.
•Do not clean your device using steam cleaners.
•Do not expose your device to water.
•Never immerse your product in any liquid for cleaning.
7