PacLights FPNN Series Installation Manual

INSTALLATION GUIDE
FPNN - 22D30
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PacLights fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNINGS:
• Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sharp objects.
CAUTION:
• For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened fi rmly. Apply weatherproof silicone
sealant around the edge of the Back Box and/or Junction Box. This is especially important with an uneven wall surface. Silicone all plugs and
unused conduit entries.
PIR/DAYLIGHT SENSOR (OPTIONAL)
All models of FPNN are Bluetooth Network Conrol enabled. Remove
the Sensor Cover (Fig. 1). Install the PIR Sensor to the FPNN fi xture by
attaching the Connector to the PIR Sensor and press into place on the
FPNN fi xture (Fig. 2).
PIR SENSOR
FPNN FIXTURE
SENSOR COVER
FIG. 1
WIRING DIAGRAM
Connect the ACL and the ACN from the FPNN Fixture to the conduit with the AC power Supply Cable. Follow the Wiring Diagram provided.
AC POWER SUPPLY
PL_INST_FPNN_v0
FPNN Series LED Flat Panel
CONNECTOR
FIG. 2
HOT [BLACK]
NEUTRAL [WHITE]
GROUND [GREEN]
Need help? (800) 988 -6386 Email: CS@PacLights.com Website: www.PacLights.com
Instructions and specifi cations are subject to change at any time without notice. Copyright© 2022 PacLights All Rights Reserved
FPNN - 24D50
IMPORTANT
RESET / DECOMMISSION
A FPNN fi xture can be de-commissioned from any Network Zone
manually by 'long pressing' for 5 seconds the 'Reset' Button that is located
on the Bluetooth Driver inside the FPNN fi xture Panel. Lift the fi xture
Panel Cover (Fig. 3). The 'Reset' Button is located at the end of the
Bluetooth Driver between the Wire Connectors (Fig. 4).
FPNN FIXTURE
FIG. 3
FPNN DRIVER
FPNN - 14D30
DRIVER
'RESET'
BUTTON
PANEL
COVER
FIG. 4
CONNECTORS
FPNN FIXTURE
Page 1 of 3