jaz TEJZANCBTTWSW Manual page 4

UK
INSTRUCTION MANUAL
Charging the box:
Connect the box to a charger using the cable provided. The LEDs
will display how much charge the box has: between 0-25%, the first
led will flash; between 26-50%, the first led will light up and the
second one will flash; between 51-75%, the first two leds will light
up and the third one will flash; between 76-99%, the first three leds
will light up and the fourth one will flash; at 100%, all four leds will
light up and not flash.
Recharging the earphones:
insert the earphones into the fully charged box; the white LED will
start flashing. If the box has no charge, the LED will not light up.
Charge level check: between 0-3%, the first LED will flash; between
4-25%, the first LED will light up; between 26-50%, the first two
LEDs will light up; between 51-75%, the first three LEDs will light
up; at >75%, all four LEDs will light up. Please correctly insert the
earphones into their respective slots.
Power earphones on/off:
Method 1 = to switch on, open the charging box and take out the
Method 2: To turn on, press the touch button for 2 seconds. The
Pairing to your phone:
Method 1 = press the 'touch' button on the headset for
Method 2 = open the charging box; after a few seconds, the earbuds
If the connection is successful, you will hear the message
'Connected' and the blue LED will start flashing every 5 seconds.
After 5 minutes of inactivity, the connection will end automatically.
4
earphones (wait at least one second before taking
them out); to switch off, put them back in the box and
close the cover.
earphones will turn themselves off after 5 minutes of
inactivity.
approximately 2 seconds, the earphones will pair
with each other; once paired, activate your phone's
Bluetooth® and search for the headset in the device list,
then select it.
will go into automatic pairing mode. Once paired,
activate your phone's Bluetooth® and search for the
earphones in the list, then select them.