VTech SWITCH&GO WOLF FIRE CHIEF Instruction Manual page 4

INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the bottom of the unit, use a
screwdriver to loosen the screw and then open the battery cover.
3. Remove old battery by pulling
up on one end of the battery.
4. Install 1 new AAA (LR03/AM-4)
battery following the diagram
inside the battery box. (For
best performance, alkaline
batteries or fully charged Ni-
MH rechargeable batteries are
recommended.)
5. Replace the battery cover and
tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
4