Magellan DirectRoute 3.0 Quick Start Manual page 20

Each time you create a street route on the GPS receiver it becomes activated
and ready to start guidance as soon as it is calculated. Only one street route can
be active. A street route stays active until you deactivate it or you reach your
destination– even if you power off and power up the unit. If you get off-
course, you can easily re-route to the current destination from your current
location by pressing the GOTO key and pressing it again at the Street Route
window. DirectRoute also keeps a list of the last 10 POI and address
destinations used, so if you stop routing but later want to route to that
destination again, it's easy.
Street routes cannot be saved as such. However, you can make a street route
from a saved point-to-point route, if the start and end points are within the
active detail map. If you want to do this, DirectRoute uses only the start and
end points of the waypoint route, and it calculates and activates the shortest-
time street route. You can also convert previous destination points to user
waypoints, and route to them whenever you wish.
Routing with the GOTO Key
The GOTO key on the handheld is the focal point of street routing. Use it to
create a street route between your current location and a destination you
specify. There are three ways to define a destination :
• Move the map cursor to the destination
• Type in an address for the destination
• Select a point of interest category or a saved waypoint
• Pick from the last ten previous destinations
18