Soap Bottle - Craftsman CMCPW1500 Instruction Manual


WARNING: Risk of Unsafe Operation. Before servicing unit unplug or disconnect electrical supply, turn water
supply off, discharge residual pressure, and engage spray handle lock-off.
PROBlEM
Motor does not start.
Unit does not reach high pressure.
Output pressure varies high/low.
No detergent.
Garden hose connection leaks.
Suction hose does not self prime.
Spray wand or extension leaks.
Pump is excessively noisy.
Water leaks from pump.
Oil leaks.
Motor buzzes but fails to run.
TROUBLESHOOTING
CAUsE
Battery packs not installed properly.
Battery packs not charged.
Speed selector switch is in the OFF position.
Wand trigger not being squeezed.
Battery port cover not latched.
Water faucet not fully turned on.
Water inlet filter clogged.
Nozzle worn.
Pump is sucking air.
Water supply restricted.
Not enough inlet water supply.
Pump is sucking air.
Water inlet screen clogged.
Discharge nozzle is obstructed.
Soap bottle is empty.
Soap bottle not properly connected.
Detergent is too thick.
Damaged or clogged detergent suction ports.
Discharge nozzle is obstructed.
Loose fittings.
Missing/worn rubber washer.
Loose fittings.
Filter not fully submerged.
Spray wand not properly attached.
Broken O-ring.
Pump is sucking air.
Loose fittings.
Water seals are damaged or worn.
Oil seals are damaged or worn.
System has residual pressure.
Pressure washer was not used for long periods.
CORRECTiOn
Check battery pack installation.
Check battery pack charging requirements.
Toggle switch to the HI or LO position.
Squeeze trigger with switch in ON position.
Press battey port cover fully closed.
Open water valve fully.
Remove filter and rinse to clean.
Replace with new nozzle.
Check that hoses and fittings are air tight. Turn OFF machine and purge pump by squeezing trigger
until a steady flow of water emerges from the nozzle.
Check water hose for kinks, leaks and blockage.
Turn water on full force - check hose for leaks and kinks.
Check that hoses and fittings are air tight. Turn OFF machine and purge pump by squeezing trigger
until a steady flow of water emerges from the nozzle.
To unclog, rinse OFF with water.
Blow out or remove debris.
Add more detergent.
Check connections. Ensure that the soap bottle is fully secured to the spray wand.
Use detergent recommended for use in pressure washers only. Follow manufactures dilution directions.
Remove obstruction or debris and run warm water over the detergent suction ports.
Blow out or remove debris. Run warm water through nozzle to remove debris
Tighten fittings.
Replace washer in hose adapter.
Tighten fittings.
Adjust float and ensure filter stays fully covered with liquid.
Please refer to Assembling Spray Wand under Assembly and Adjustments.
Contact CRAFTSMAN customer service representative at 1-888-331-4569.
Check that hoses and fittings are air tight. Turn OFF machine and purge pump by squeezing trigger
until a steady flow of water emerges from the nozzle.
Check that all fittings are tight.
Contact CRAFTSMAN customer service representative at 1-888-331-4569.
Contact CRAFTSMAN customer service representative at 1-888-331-4569.
Turn unit off, squeeze trigger on spray wand to release pressure, then turn unit on.
Contact CRAFTSMAN customer service representative at 1-888-331-4569.
English
15