Table of Contents
Advertisement
charge, the T-Link2 will power off even if the
power switch is ON. If ID Z is the only T-Link2
powered on, the LED will quick flash red each time
it transmits. When other T-Link2s are powered on,
the LED will flash green when a wireless signal
is received. During normal operation, the LED
on each T-Link2 will flash red during transmit
and flash green each time signal is received from
another T-Link2.
The wireless SBD Timer requires a PC with
data capture or race management software to
publish the race results.
USING WIN LIGHTS
Optional Win Lights can be connected to T-
Link2 Wireless units ID'A' and ID 'B' using cable
part number 05-5826.
When the Win Lights are not indicating a
winning lane they are continuously waiting for
TYPICAL SBD TRACK SETUP
Figure 1 - T-Link Wireless SBD Layout
RaceAmerica 5812 Wireless SBD Timer
the first beam to be blocked. Once a finish is
detected, the Win Light for that lane will flash
for 10 seconds, then clear automatically and
return to idle state waiting for the next beam to
be blocked.
USING PC SOFTWARE
Locate the T-Link2 unit identified as ID 'Z'.
Locate the T-Port connector on the back of the T-
Link2 unit. Connect this T-Port to a 9-pin serial
PC port using the 06-TL02 data communications
cable. Power on ID 'Z' and observe the right LED
illuminates and blinks off, then on very quickly
appearing as a flicker. If ID 'Z' is the only T-Link2
powered on, no other LEDs will illuminate. When
other T-Links are powered on, the center LED
will flash when a wireless signal is received from
another T-Link2 unit. The left LED will flash very
quickly indicating ID 'Z' is receiving a good signal
5
Advertisement
Table of Contents
