Advertisement
To set the a mode, first press on
and then on
. As you can see in the display, the mode will
change. To set the spa in another mode, press again on 'cool' and 'mode'.
Jets 1
Jets is a massage pump. When you press the button Jets 1
, pump 1 will be activated. When
pressing again on Jets 1
, the pump will be disactivated. There is a special safety programmed in
the spa. When a massage pump is running, it will disactivate automatically 15 minutes after
activation.
Jet 2 (Only works when spa has 2 or 3 massage pumps)
Jets 2 has the same function as Jets 1. There is one difference, the Jets 2 button controls two
separate pumps. When pressing the Jets 2
button for the first time, pump 2 will be activated. By
pressing it for the second time, pump 3 will be activated. By pressing it for the third time, pump 2 will
be disactivated. By pressing it for the fourth time, pump 3 will be disactivated.
Blower
The blower is a special air pump, which will blow air bubbles through the air jets. To activate the
blower, press
. By pressing the blower button again the blower will be disactivated. Also the
blower, will be disactivated automatically after 15 minutes.
Light
To switch on the light, press
. To switch off the light, press the light button again. Also the light
has a special factory safety setting. When the light has been activated, it will be disactivated
automatically after 4 hours.
Set the filter cycle
In the filter cycle, the circulation pump will circulate and filter the water to make sure the water
remains clear and clean(together with the sanitizer). To set the filter cycle, press the following button
combination within 3 seconds:
and
. When pressed, you can see 'SET START FILTER 1 (AM)' in
the display. By pressing the 'cool' or 'warm' button, you can set the desired start time. By pressing
you can also set the minutes. Press
again, When pressed, you can see 'SET START FILTER 2' in
the display. To set the end-time, press 'cool' or 'warm'. To set the second filtercycle, press again on
. Just repeat the same as you did with Filter cycle 1 but, make sure you do PM instead of AM!
Otherwise both filtercycles will run at the same time, which means there will be just 1 cycle. When
you have set all the times, keep pressing
untill you can see the current water temperature in the
display and the settings will be saved.
Panel lock
You can lock the panel by pressing a button combination within 3 seconds. To lock the panel, press:
Time, Blower, Warm. As you can see in the display, the panel lock is activated. You can press every
button you want but, nothing will be activated. To unlock the panel, you have to press the following
combination within 3 seconds: Time, Blower, Cool.
Temperature lock
You can lock the set-temperature by pressing the following combination: Warm, Time, Blower. Whet
temperature lock is activated, the temperature cannot be changed. To unlock the temperature lock,
press : Cool, Time, Blower. Right now you are able to set the desired temperature again.
Advertisement
