Connections; Placement - Mackie SWA1501 User Manual

CONNECTIONS

The SWA1501 has two female XLR in-
puts that accept a balanced line-level signal.
When connecting a balanced signal, be sure
it's wired per AES (Audio Engineering So-
ciety) standards:
XLR
Hot (+) Pin 2
Cold (–) Pin 3
Shield (Ground) Pin 1
Balanced XLR Connectors
If connecting an unbalanced signal to the
SWA1501 balanced input, be sure that the
signal high (hot) connection is wired to Pin 2
and the unbalanced ground connection is
wired to the low and the ground connec-
tions of the balanced input (Pins 3 and 1).
If there are ground-loop problems, try con-
necting the unbalanced ground connection
only to the input low connection (Pin 3),
and leaving the input ground connection
disconnected.
There are also four male XLR connec-
tors labeled THRU (FULL RANGE OUTPUT)
and HIGH PASS (MID/HIGH FREQ) OUTPUT.
These are also wired according to the
AES standard.
Unbalanced Male XLR Connector
6
The THRU output connectors allow you
to connect more than one SWA1501 to
your system. Simply plug the signal source
(i.e., mixer output) into the first speaker's
FULL RANGE INPUT jacks, and patch that
speaker's THRU jacks to the next speaker's
INPUT jacks, and so on, daisy-chaining
multiple speakers.
The THRU jack is wired straight from the
FULL RANGE INPUT connector — there is
no electronic circuitry between — so the
signal coming out of the THRU jack is ex-
actly the same as the signal going in.
The HIGH PASS OUTPUT jacks provide a
line-level signal of the frequencies above
120Hz that you connect to a pair of active
speakers (or to a stereo amplifier powering
a pair of passive speakers). See the dia-
grams on the rear panel of the SWA1501
for additional connection information.

PLACEMENT

The SWA1501 subwoofer is designed to
sit on the floor or on sturdy stands.
A socket is provided on the top of the
SWA1501 for mounting the Mackie
SRM450 active speaker. Use the optional
Mackie speaker mounting pole to mount
the SRM450 on the SWA1501 (see Hookup
Diagram on page 5).
As with any powered
components, protect the
SWA1501s from exposure
to moisture. If you are
setting them up outdoors,
make sure they are under
cover if you expect rain.
WARNING: The cabinet
has no rigging points and
is not suitable for rigging.
NEVER attempt to sus-
pend the SWA1501 by its
handles.