Mackie SWA1801 User Manual

Mackie SWA1801 User Manual

Active subwoofer system
Hide thumbs Also See for SWA1801:

Advertisement

SWA1801
ACTIVE SUBWOOFER
SYSTEM USER'S MANUAL
ACTIVE
LIMIT
THRU
(FULL RANGE OUTPUT)
POWER
115V-AC FUSE AC125V-T6.3A
CONCEIVED AND DESIGNED BY MACKIE DESIGNS INC, WOODINVILLE, WA, USA AND MACKIE EUROPE
• MADE IN ITALY • COPYRIGHT ©2000 • THE FOLLOWING ARE TRADEMARKS OR REGISTERED
TRADEMARKS OF MACKIE DESIGNS INC.: "MACKIE", AND THE "RUNNING MAN" FIGURE • PATENT PENDING
SIGNAL
THERMAL
POWER
PARALLEL
SUBWOOFER
HIGH PASS
FULL RANGE
CONTROL
(MID/HIGH FREQ)
INPUT
OUTPUT
120Hz
NORMAL
L
L
SUBWOOFER
LEVEL
IN
OUT
NORMAL
R
R
REV 180
PHASE
ON
SWA1801
ACTIVE SUBWOOFER

Advertisement

Table of Contents
loading

Summary of Contents for Mackie SWA1801

  • Page 1 CONCEIVED AND DESIGNED BY MACKIE DESIGNS INC, WOODINVILLE, WA, USA AND MACKIE EUROPE • MADE IN ITALY • COPYRIGHT ©2000 • THE FOLLOWING ARE TRADEMARKS OR REGISTERED TRADEMARKS OF MACKIE DESIGNS INC.: "MACKIE", AND THE "RUNNING MAN" FIGURE • PATENT PENDING...
  • Page 2: Safety Instructions

    11. Object and Liquid Entry — Care should be taken so that objects ELECTRIQUE, NE PAS ENLEVER LE COUVERCLE. AUCUN do not fall on, and liquids are not spilled into, this Mackie product. ENTRETIEN DE PIECES INTERIEURES PAR L'USAGER. CONFIER L'ENTRETIEN AU PERSONNEL QUALIFIE.
  • Page 3: Table Of Contents

    Thru jacks are provided for daisy-chaining the of having the amplifier located within the subwoofer signal to additional SWA1801 cabinets. The cabinet is that the SWA1801 functions as a system, optimizing acoustic, electronic, and mechanical built-in crossover separates the low frequencies...
  • Page 4: Rear Panel Description

    CONCEIVED AND DESIGNED BY MACKIE DESIGNS INC, WOODINVILLE, WA, USA AND MACKIE EUROPE • MADE IN ITALY • COPYRIGHT ©2002 • THE FOLLOWING ARE TRADEMARKS OR REGISTERED TRADEMARKS OF MACKIE DESIGNS INC.: "MACKIE", AND THE "RUNNING MAN" FIGURE • PATENT PENDING...
  • Page 5: Hookup Diagrams

    Plays the Low Hi-Pass Hi-Pass Frequencies ACTIVE Out L ACTIVE Out R Power Cord Line-Level Power Hi-Pass Out Cord SWA1801 Plays the Low Power Stereo Power Frequencies Cord Amplifier 1 SWA1801 WITH STEREO AMPLIFIER AND 2 C300 1 SWA1801 WITH 2 SRM450...
  • Page 6: Connections

    CONNECTIONS The THRU output connectors allow you The SWA1801 has two female XLR in- to connect more than one SWA1801 to puts that accept a balanced line-level signal. When connecting a balanced signal, be sure your system. Simply plug the signal source it’s wired per AES (Audio Engineering So-...
  • Page 7: Ac Power

    AC POWER Be sure the SWA1801 is plugged into an If the thermal switch activates frequently, outlet that is able to supply the correct volt- try turning down the level control a notch age specified for your model. If the voltage...
  • Page 8 Make sure the connecting based device on the same AC circuit as cables are in good repair and securely the SWA1801? Use an AC line filter or connected at both ends. Make sure the plug the SWA1801 into a different AC output volume (gain) control on the circuit.
  • Page 9: Repair

    Repair Service for the SWA1801 is available 4. Pack the subwoofer in its original packaging, including protective wrap, only from one of our authorized domestic service stations or at the factory service cen- endcaps, and box. This is very impor- tant.
  • Page 10: Swa1801 Specifications

    Floor mount only Thermal Protection Input stage muting, WARNING: The cabinet has no rigging points auto-reset and is not suitable for rigging. NEVER attempt to suspend the SWA1801 by its handles. Transducer Specifications Low-Frequency Transducer Diameter 18˝ (457 mm) Disclaimer Voice Coil Diameter 4.0˝...
  • Page 11: Architect's And Engineer's Specifications

    SWA1801 On Axis Frequency Response (with second and third harmonic components) Fundamental Second Third Frequency (Hz) Architect’s and Engineer’s Specifications The active subwoofer loudspeaker system functions. The system shall accept a stan- shall incorporate one 18-inch low-frequency dard line-level signal via the XLR input (LF) transducer mounted within a vented connectors.
  • Page 12 ™ ® Mackie Designs Inc. Mackie Designs Inc. 16220 Wood-Red Rd. NE • Woodinville, WA 98072 • USA US & Canada: 800/898-3211 Europe, Asia, Central & South America: 425/487-4333 Middle East & Africa: 31-20-654-4000 Fax: 425/487-4337 • www.mackie.com E-mail: sales@mackie.com...

Table of Contents