Table of Contents
Advertisement
Using the Label Peeler
11
(Optional: PA-LP-001)
(TD-2125N/TD-2135N/
TD-2125NWB/TD-2135NWB only)
Use the (optional) Label Peeler to print labels
automatically and peel off the label backing
before they are fed out of the media exit slot.
Follow the procedure below to load the
correct paper.
For more information on attaching the label
peeler (optional), see its instruction manual.
Before using the label peeler, the
setting for using the label peeler must
be specified in the printer driver. For
more information, see Printer Driver
Settings on page 90.
Inserting the Media Roll
When using the peeling function of the
label peeler to peel off labels while
printing:
We recommend to use genuine
Brother roll media.
Be sure to use die-cut labels. Do not
use any other labels.
a
Press and hold the
turn the printer off.
Press the cover release lever (1) on
either side and lift to open the Media Roll
compartment top cover.
11
b
Open the media guides by lifting the
media guide adjustment lever (1) and
pulling the media guides outwards.
NOTE
The media guides are shipped fully open
from the factory.
11
(Power) button to
1
11
1
87
Advertisement
Table of Contents
