Technical Data - BorMann PRO BEM1800 Owner's Manual

EN
(8) The machine CANNOT be over loading!
(9) The electrical cable CANNOT be too far away the machine, CANNOT pull the cable to disconnect the plug from the socket directly! Keep the cable from
heating, damp, scratch!
(10) DO only use no scratch,no defected cable with plug!
(11) DO pull off the power source when the machine is out of work, maintenance or changing the mixing operation!
(12) DO NOT mix the material which flammable pointless than 210C .
(13) DO NOT use solvents for cleaning the tools! Unless it will have explosion dangerous!
(14) DO NOT install and operator the machine in the flammable and explosive circumstance! Unless it will have explosion dangerous!
(15) DO NOT use the slide or movable mixing drum!
(16) DO NOT star the mixer until the mixing tools is in the mixing drum or other drums!
(17) DO NOT run idle of the machine!
(18) DO NOT take out the sample until the machine is stopped! DO NOT touch into the mixing drum when the machine is in operation!
(19) DO NOT star the machine when the dried materials is in the drum or stick to the drum!
(20) The machine will not be failure only you operate it carefully!
(21) Please wear goggle and ear cap when operating the machine!
(22) DO use only original spare parts for the machine maintenance!

Technical Data

Voltage/frequency:
Power:
No-load Speed:
Mixing paddle diameter :
Protective type/protective class:
No. of gears:
Tool fitting/Clamp thread:
Description of main parts (picture A)
1. ON / OFF switch
2. Switch lock
3. Speed control wheel
4. Speed selector switch
5. Tool mount
6. Supplementary handle
7. Ventilation apertures
8. Wrench
9. Whisk
Operating instructions
WARNING! DANGER OF INJURY! Switch the device off and pull the plug out of the mains socket before carrying out any work in the device.
Before first use
WARNING! DANGER OF INJURY! Switch the device off and pull the plug out of the mains socket before carrying out any work in the device.
Placing a whisk
NOTE: Use only whisks conform the specified diameter.
- Screw the whisk with thread (M14) as far as possible in the tool
- Tighten the whisk properly with an open-end wrench.
First use
The mains voltage at the mains socket must match that shown on the rating plate on the device.
Using
Improper use may damage the instrument. Observe therefore these instructions:
- Use a tool up to the specified diameter.
- Load the tool in such a way that the speed would not drop considerably or that it would stop.
Check if the data on the rating plate correspond with the actual mains voltage.
Switching on and off
- To switch on the tool, press and hold the on/off switch (1).
- If you release the on/off switch, the tool will be switched off.
Switch locking mechanism
You can lock the on/off switch by pressing the on/off switch (1) and then button (2). The switch lock can be released by briefly pressing the on/off switch.
4
230V/50Hz
1800W
I:180-400(min),II:300-700(min)
140mm
Double insulation/II
2
M14 x 2
WWW.BORMANNTOOLS.COM